Punches

A quick and easy way to cut clean square holes in sheet metal up to 16 gauge. The special design allows an even load during cutting and produces a burr free hole that needs n...

Q.Max Thrust Races are recommended to increase punch life and to significantly ease the operation of the punch. Makes cutting the holes effortless.This 10mm Thrust Race is sui...

Q.Max Thrust Races are recommended to increase punch life and to significantly ease the operation of the punch. Makes cutting the holes effortless.This 12mm Thrust Race is sui...

Q.Max Thrust Races are recommended to increase punch life and to significantly ease the operation of the punch. Makes cutting the holes effortless.This 16mm Thrust Race is sui...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...

A hardened and tempered parallel pin punch, which is used for removing pins in parallel holes. The pin should be first started with a hand or taper punch to avoid damage to t...