The Sartra® Fusion 46 Strimmer Head is a tap feed strimmer head for larger Stihl brushcutters from the FS 360 to the FS 490. It loads in 60 seconds, cuts low to the ground and has an anti-vibration design. It comes with an M12 x 1.5 left-hand adaptor bolt already mounted, so it’s ready to fit. It’s an alternative to the Stihl® AutoCut Head 46-2. Loads in 60 Seconds. The head is quick and simple to reload, so you spend less time stopped and more time cutting. Tap to Feed. Tap the head on the ground while it’s running to release more line. You don’t need to stop and pull out line by hand. Spinning Metal Knob. The metal knob at the bottom of the head spins as it touches the ground. This reduces friction, so the head wears less when you tap it or work close to the ground. Low Cutting Height. The head is designed to cut close to the ground, which gives a neater finish along edges and on short grass. Less Vibration. The anti-vibration design reduces the vibration that reaches your hands and arms, which means less fatigue over a long day of brushcutting. Mounted Adaptor Bolt. The head comes with an M12 x 1.5 left-hand female adaptor bolt already fitted. Compatible Models. Stihl FS 360 C-EM Stihl FS 410 C-EM and FS 410 C-EM L Stihl FS 460 C-EM and FS 460 C-EM L Stihl FS 490 C-EM and FS 490 C-EM L Check your machine’s model number before ordering. For smaller Stihl machines from the FS 55 to the FS 240 C-E, use the Sartra® Fusion 26 Strimmer Head. Compatible Razorline Strimmer Line. The head takes Sartra® Razorline strimmer cord in these sizes. Round 2.4mm (2357), 2.7mm (2681) and 3.0mm (2358) Square 2.4mm (2361), 2.7mm (2371), 3.0mm (2362) and 3.3mm (2372) Work Safely. Always stop the engine and wait for the head to stop turning before you adjust or reload the line. Wear eye protection, hearing protection, gloves and leg protection when strimming.